The Yaesu FT-1000MP Mark-V represents the crowning achievement in Yaesu's HF transceiver design history. A unique blend of analog and digital technology, the Mark-V is based on the concept of rigorous filtering in all stages of the receiver and transceiver. A high speed antenna tuner is built in. This radio includes a hand mic.
The Mark-V ADDS five all-new features
to the FT-1000 Series:
*IDBT (Interlocked Digital
Bandwidth Tracking), which matches the
receiver passbands of the 8.2 MHz IF, 455 kHz IF and DSP systems.
*VRF (Variable RF
Front-end Filter), providing a high-Q "Preselector"
system protecting the receiver's front end.
*Class A PA Operation,
providing extraordinary SSB signal purity.
*200-Watt MOS FET Final
Amplifier, giving you the extra drive for your linear.
* Integrated Shuttle Jog
Control, combining the access buttons for IDBT and VRF with the
convenient frequency control of Yaesu's exclusive Shuttle Jog.
|
· Dual Receive· Class A PA Operation· Integrated Shuttle Jog Control· 10 Pole Collins Mechanical Filter· Manual and DSP Auto Notch |
· 200 Watts Power!· Separate FP-29 Power Supply· Enhanced DSP· 13 Tuning Steps· Manual and Auto AGC |
FT-1000MP Mark V Specifications
| GENERAL | 0 |
|
RX Frequency Range: |
100 kHz ~ 30 MHz |
|
TX Frequency Ranges: |
160 ~ 10 m (Amateur bands only) |
|
Frequency Stability: |
±0.5 ppm (after 1 min. @ 25 °C) |
|
0 |
±0.25 ppm (after 1 min. @ 25 °C, w/TCXO-6) |
|
Operating Temperature Range: |
-10 °C ~ +50 °C |
|
Emission Modes: |
LSB, USB, CW, FSK, AFSK, AM, FM |
|
Frequency Steps: |
0.625/1.25/2.5/5/10 Hz for SSB,CW, RTTY & Packet |
|
0 |
100 Hz for AM and FM |
|
Antenna Impedance: |
16.6 ~ 150 Ohms, unbalanced (Tuner ON, TX only) |
| Power Consumption: | 13.8 VDC | 30 VDC |
| RX (no signal) | 2.3 A | - |
| RX (signal) | 2.7 A | - |
| TX (200 W) | 2.2 A | 14.5 A |
| Supply Voltage: | 30 VDC and 13.8 VDC (FP-29) |
| Dimensions (WHD): | 16" x 5.3" x 13.7" (410 x 135 x 347 mm) |
| Weight (approx.): | 31 lbs. (14 kg.) |
| 0 | |
| TRANSMITTER | 0 |
| Power Output: | Adjustable up to 200 watts (50 watts AM carrier), |
| Class A mode (SSB): | 75 watts maximum |
| Duty Cycle : | 100% @ 100 watts, |
| 0 | 50% @ 200 watts (FM & RTTY, 3-minute TX) |
| Modulation Types : SSB: | J3E Balanced, |
| AM: | A3E Low-level (early stage), |
| FM: | F3E Variable reactance, |
| AFSK: | J1D, J2D Audio frequency shift keying |
| Maximum FM Deviation: | ±2.5 kHz |
| FSK Shift Frequencies: | 170, 425 and 850 Hz |
| Packet Shift Frequencies: | 200 and 1000 Hz |
| Harmonic Radiation: | Better than -60 dB (Typical) |
| SSB Carrier Suppression: | At least 40 dB below peak output |
| Undesired Sideband Suppression: | At least 55 dB below peak output |
| Audio Response (SSB): | Not more than -6 dB from 400 to 2600 Hz |
| 3rd-order IMD: | - 31 dB @ 200 watts PEP, or better |
| 0 | (Class A mode) - 50 dB @ 75 watts PEP (Typical) |
| Microphone Impedance: | 500 to 600 Ohms |
| 0 | |
| RECEIVER | 0 |
| Circuit Type: | Quad-conversion superheterodyne (triple conversion for FM) |
| Intermediate Frequencies: | 0 |
| Main RX: | 70.455 MHz/8.215 MHz/455 kHz, |
| Sub RX: | 47.21 MHz/455 kHz |
| Sensitivity : | ||
| Modes | 0.5 - 1.8 MHz | 1.8 - 30 MHz |
| SSB/CW (2.0 kHz) | 2 uV | 0.16 uV |
| AM (6 kHz) | 13 uV | 2 uV |
| FM | - | 0.5 uV |
| (with preamp on, IDBT on, SSB/CW/AM for 10 dB S/N, FM for 12 dB SINAD, 0 dB u = 1 uV) | ||
| Selectivity (-6/-60 dB) : | |||
|
BandWidth |
Modes | Min. -6 dB BW | Max. -60 dB |
| BW | |||
| 2.4 kHz | all except FM | 2.2 kHz | 4.2 kHz |
| 2.0 kHz | all except FM | 1.8 kHz | 3.6 kHz |
| 500 Hz | CW/RTTY/Packet | 500 Hz | 1.8 kHz |
| 250 Hz | CW/RTTY/Packet | 250 Hz | 700 Hz |
| 0 | AM (Wide) | 4 kHz | 14 kHz |
| 0 | FM | 8 kHz | 19 kHz |
|
IF Rejection (1.8 ~ 30 MHz): |
80 dB or better (Main RX), 60 dB or better (Sub Rx) |
|
Image Rejection (1.8 ~ 30 MHz): |
80 dB or better (Main), 50 dB or better (Sub) |
|
Maximum Audio Output: |
2.0 W into 4 Ohms with <10 % THD |
|
Audio Output Impedance: |
4 to 8 Ohms |
| 0 | |
|
FP-29 Specifications |
0 |
|
DC Output Voltage/Current: |
+30 V: 15 A; +13.8 V: 3 A |
|
Input Voltage: |
AC 100-120 V, 50-60 Hz |
|
0 |
AC 200-240 V, 50-60 Hz |
|
Current Consumption (Approx.): |
AC 100-120 V: 9 A, AC 200-240 V: 5 A |
|
Operating Temperature Range: |
-10°C ~ +50°C |
|
Case Size (W x H x D): |
4.2"x 5.3"x 13" (106 x 135.5 x 331 mm) |
|
Weight (Approx.): |
7 lbs.(3.2 kg.) |
| 0 | |
| Specifications are subject to change, in the interest of technical improvement, without notice or obligation. | |